RUN time in Abaqus less than 1minut

[Rana741]

RUN time in Abaqus less than 1minutes it that ok or there might be a mistake

 

[FEA way]

It depends on the model. Analyses in Abaqus may take from a few seconds (for very simple and small models) to a few days.

 

[Rana741]

I am modelin a flat slab model is it okay for that or there might be an error

 

[BridgeSmith]

The time to run the analysis does not indicate an error; the output will indicate an error; either by an error message, or by results that are not reasonable.

The analysis of a slab can be very simple and quick or very complex and time consuming, depending on the number of nodes in the mesh.

Rod Smith, P.E., The artist formerly known as HotRod10

 

[Rana741]

I am modeling a lightweight flat slab to check punching. But the after analysis the results seems not reasonable. I attached the file since i can not find the error