Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

running ANSYS 13 mechanical on MATLAB for optimization

Status
Not open for further replies.

lopessilva

Mechanical
Nov 26, 2011
49
Hello,

I´m running ANSYS 13 mechanical on MATLAB. I´m trying to run optimization on an ANSYS input file. Can you tell me what is the command to run ANSYS 13 mechanical on MATLAB?

I know I should use the dos command, but I don´t know the correct syntax.

regards,
Hugo

 
Replies continue below

Recommended for you

You need to ask in an ansys forum not a matlab one. Your support people should be able to tell you

Once you know the command you need then the matlab is just


dos('your command line goes here')

Cheers

Greg Locock


New here? Try reading these, they might help FAQ731-376
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor