we have seen a lot of rejection for "in line" rusting during our vibro finish processes. This especially becomes the case when there is a short power failure and the parts in the vibrators become extremely prone to rust...we do have power backup but we do see a lot of rejects ...any expert on vibro finishing with recommendations...our process is very suspect and i would be willing to doubt every process paramater.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
Rust Issue on Vibrofinishing 4
- Thread starter ajxxx
- Start date
I recommend that you take a look at the Mechanical Finishing section at PFOnline, and also contact Steve Marcus of The Markee Corporation. There is a lot of good information available from both sources:
-
1
- #3
-
3
- #4
I would never put oil in any type finisher with porous media unless you want toss out the media. Here are two products that are used to prevent flash rust on ferrous parts that are to be coated of painted.
- Status
Similar threads
- Locked
- Question
- Locked
- Question