Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

S7- Soucre Code for Scale Routine

Thread starter AndyHill
Start date Feb 26, 2003

Status: Not open for further replies.

Feb 26, 2003

AndyHill

Electrical

Can any one help,
I'm looking for source code for the generic Scale routine that comes with the S7-300 range of PLC's. Reason being that I want to edit and change it to improve it so that I can calibrate between any two points rather than fixed points.

Andy