Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

SA-193 B8 Cl.2 & SA-193 B8M Cl.2 Bolts - UHA-51(c)(1) & UHA-51(d)(1)(a)

Status
Not open for further replies.
wsmith22

wsmith22

Mechanical
Nov 9, 2005
67
Are these bolts impact test exempt per UHA-51(d)(1)(a) to -320 deg F? I assume the bolts are thermally treated above 1650 deg F per UHA-51(c)(1) even though the material specification does not give a solution anneal temperature. I have asked for our bolt supplier to provide more information since I do not see a solution anneal temperature on any of the MTR's we have been provided.
 
Status
Not open for further replies.

Similar threads

FPPE
  • Locked
  • Question
SA-193 B8 CL2 bolts torque for B16.5 Ring Joint #2500 and #600 application
Replies
7
Views
2K
GD2
GD2
KD007
  • Question
SA-193 Gr.B7M bolt material used in Wet H2S service is not passing requirement of UG44b clause.
2
Replies
20
Views
9K
r6155
r6155
LC-24
  • Question
UG-36(c)(3)(-a)(-1)/(-2) "Small Opening" Exemption
Replies
2
Views
990
LC-24
LC-24
I
  • Question
According to ASME Section II Part D, the size limit for SA-193 B7M is 100mm in SI units and 2.5 inches in US units. Are there any other reasons?
Replies
4
Views
2K
XL83NL
XL83NL
G
  • Question
BPVC Div 1 Bolt Load Mandatory Appendix 2.
Replies
4
Views
2K
XL83NL
XL83NL

Part and Inventory Search

Sponsor

Back
Top Bottom