Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

SACS

Status
Not open for further replies.
padeyedesigner

padeyedesigner

Structural
Jun 22, 2011
3
CAN ANYBODY TELL ME THE ANSWER FOR FOLLOWING ?

WHICH AREA'S TAKING FOR MAJOR AXIS SHEAR OF I SECTION IN SACS ANALYSIS SOFTWARE ?
WHETHER IS IT TAKING FULL TWO FLANGE AREA'S OF I SECTION ?

YOUR VALUABLE ANSWERS ARE HIGHLY APPRICIATED.

BY AYYAPPAN.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
padeyedesigner,
Perhaps if you re-type your question in a more polite manner you may receive answers. Note "Bold" type is considered as shouting which is not acceptable!!!!
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

adityabodhe86
  • Locked
  • Question
SACS OFFSHORE DESIGN
Replies
0
Views
14
adityabodhe86
adityabodhe86

Part and Inventory Search

Sponsor

Back
Top Bottom