Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

SAE FLANGES

Status
Not open for further replies.
dillbuck

dillbuck

Mechanical
Aug 29, 2002
1
Are 4-bolt square SAE flanges acceptable to use on ASME Section VIII, Div. 1 pressure vessels?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Duckbill, Did you ever receive an answer to your question?
Thanks
FilterDude
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

GinBread
  • Locked
  • Question
Warping of Tubesheets and Flanges
Replies
9
Views
205
EdStainless
EdStainless
Mech_ash19
  • Locked
  • Question
ASME VIII-1 UG-44(b) - External Loads on Standard Flange - Analysis Options for Slip-On Flanges 1
Replies
2
Views
353
Mech_ash19
Mech_ash19
Amr Shams
  • Locked
  • Question
Opening in standard blind flanges 4
Replies
10
Views
393
Amr Shams
Amr Shams
Headphone5
  • Locked
  • Question
ASME B16.5 Flanges, What is "Minimum Thickness For Lap Joint?"
Replies
4
Views
197
Headphone5
Headphone5
billythegent
  • Locked
  • Question
ASME section VIII Swivel Flanges : for subsea applications 3
Replies
9
Views
250
billythegent
billythegent

Part and Inventory Search

Sponsor

Back
Top Bottom