SAFE Runs Analysis Twice

[Luceid]

Has anyone run into an issue where SAFE runs analysis/design and upon completion (can pan the model around for a moment) it decides to run the analysis and design again? I've got some models that take long enough to run a single time, and the glitchy extra run is really slowing the process down.

 

[JoshPlumSE]

There are design changes that can affect analysis results, right? Like if you add PT in some area then then that affects the stiffness of the slab in that area.

 

[Luceid]

That's a good point, however I'm not using any PT in this model, so I am just designing Rebar.

I know that Concept includes the rebar designed in its deflection calculations to some extent but I wasn't aware of SAFE doing a similar thing. Maybe that's what is going on.