Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Satellite Pro pointing problem 1

Status
Not open for further replies.

Skogsgurra

Electrical
Mar 31, 2003
11,815
0
0
SE
Help!

The little rubber thing above "b" on the kbd works only sporadically. Most of the time the cursor sits in the lower left corner and won't move. And then, suddenly, it starts moving all by itself - and I can move it using the little rubber knob. But only for a short while and then it goes south-west again and stays there.

Anyone knows anything about this? Virus? Hardware? Simple loose contact or shall I replace something? Please!
 
Replies continue below

Recommended for you

Status
Not open for further replies.
Back
Top