SAVE AS NX11

[Lars1978]

Hi All,

I'm a native NX11 user. When I try to perform a SAVE AS I'm prompted what new filename the NEW file should have and in sequence the new filenames off open masters are prompted.

In NX10 I could see which master I was renaming in the status bar.

I can't see this in NX11?

Lars



Lars
NX10.0.3.5 native
Solid Edge
Inventor

 

[cowski]

I don't have NX 11 up and running, but it seems that NX 9 had a similar problem. The following thread had a work-around for NX 9, perhaps it will also work for NX 11 until it is properly fixed?

thread561-356704

www.nxjournaling.com