save bug help....

[julio]

currently I'm working on a drawing for my scenior engineering design...I got to a point where everytime I try to save, pro_engineer just crashes and I'm unable to reopen the file...the single file is made of 34 sub files..I deleted the sub_file #34 and I was able to retrieve and open the drawing...The drawing contains a mixture of solids, curves, and surfaces. Everytime I creat a new boundary surface and try to save it pro_eng crashes!!!.
I'm stuck, I cannot go any further with my drawing...

Heeeeeeeelp!!!!!!!!

 

[andyb]

Hi

I assume you are using ProE2000i2, I had this problem as well the only cure is a later cut of software. I am not able to tell you which cut cured this problem (I am not at work) but I recieved it in november. I hope this helps.

Andyb