MINO9
Mechanical
- Aug 9, 2003
- 4
I am having a problem when exporting a drawing (slddrw) with GD&T (feature control frames) FCF.
In Solidworks, the leaders are "off" but in the DXF there are leaders shooting across the page. I generally need to edit the dxf before sending. I'm I missing a setting or something? Any help would be appreciated. Generally, the FCF (Feature Control Frames) are attached to dimensions.
I am using SW 2014 SP4, but this has been a problem with earlier versions too.
Any help would be appreciated.
Thanks,
Mitch
In Solidworks, the leaders are "off" but in the DXF there are leaders shooting across the page. I generally need to edit the dxf before sending. I'm I missing a setting or something? Any help would be appreciated. Generally, the FCF (Feature Control Frames) are attached to dimensions.
I am using SW 2014 SP4, but this has been a problem with earlier versions too.
Any help would be appreciated.
Thanks,
Mitch