Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Saving Appearance/Decal/JPG

Status
Not open for further replies.

freerangequark

Mechanical
May 11, 2005
88
Hi,

I have a PRT file consisting of a single cube feature. On one side of that I have used the appearance manager to create a decal using a JPG file. If I save the PRT, the appearance does not save with it.

How can I create a file that can be opened in Creo that will carry the appearance info with it. It seems that for the PRT file to open with the proper appearance, that the appearance/jpg would have to be loaded on each computer opening the file. Is there and exchange format I can "save-as" that would embed the appearance info in it? The exchange file does not have to be parametric.

Thanks,
Glenn
 
Replies continue below

Recommended for you

Status
Not open for further replies.

Part and Inventory Search

Sponsor