Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

saving as *,par into *,stl in SOLID EDGE

Status
Not open for further replies.

eldoradow

Marine/Ocean
Apr 23, 2013
2
hi
I would like to save as my solid edge file that is in *,format into stl format but just solid parts are conveted not surfaces.would you plese let me know about this truuble?
 
Replies continue below

Recommended for you

STL - Stereo lithography? format for 3D prototyping I believe only supports solids so the routine for export is masking anything that is not supported.
Try exporting a parasolid format file for use in SolidEdge.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
 
yes ,STL file that is necessary to make mesh by openfoam as snappy hex mesh. I generated CAD file but i coudnt export all parts except solid ones as STL .
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor