SolidEd
Industrial
- Oct 26, 2005
- 13
We are currently having problems with the amount of time it takes to open, save, close, even minimize and maximize files (literally minutes for moderately sized files). This is a problem that has been here since I've been here. Up to this point it had been thought that our hardware configurations were the culprits so we have spent time and money upgrading our systerms (not very top notch, but none the less much better than before) with little success.
I recently did some tests where I found that if I copy the files and linked assemblies to the local drive (c
, wait time goes from minutes, to mere seconds. We then ran perfmon on the server (dedicated server for our files) to see if we could spot the problem (hd, network, etc...). What we found is that Processor and hard drive activity are realtively low but there is a lot of information being transfered over the network even when we simply minimize an already open drawing (causing the long wait times). Network speed, CPU, HD, RAM do not appar to be factors. Why is SE transfering info here? What can I do to minimize this wait time.
Any helpful information related to this topic would be greatly appreciated.
Thanks in advance
I recently did some tests where I found that if I copy the files and linked assemblies to the local drive (c
Any helpful information related to this topic would be greatly appreciated.
Thanks in advance