SA-240 Gr. 316 Max. Temperature Limit for Sect VIII Div. 1 is 1500 F. Note G12: above 1000 F these stress values apply only when the carbon content is 0.04% or greater. I take this to mean you can't use this material above 1000 F if the carbon content is less than 0.04% carbon, because you have no stress value to use. Thoughts on this?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Section II Part D Table 1A Note G12
- Thread starter heatexguy
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Question
- Locked
- Question