Section View based off a Section View NX7.5

[jerry1423]

In NX6 I was able to create a section view based off a section view.
I can't seem to do it in NX7.5 . . . even though the section view that I want to based the new section view off of has a simple, straight, cut (no bends, rotation, or anything like that).
So am I no longer able to base a section view off of a section view in NX7.5 like I was able to do in NX6 ?

 

[jerry1423]

I found what the problem is:
What looks like a basic straight cut is actually an angled cut with the two segments colinear.