Section View in NX 5.0

[lurks]

I am working on a drawing where a section view is necessary. I have no problem creating the view but I would like to know how to adjust the overall width of the cut line. It is currently 4 - 5 times wider than the section that I am cutting. Does anybody know how to do this?

Thanks in advance,

Lurks

 

[ewh]

I'm not certain in NX5, but try RMB while hovering over the section line, Style --> Settings --> Width

"Good to know you got shoes to wear when you find the floor." - [small]Robert Hunter[/small]