I know how to create a section view; however, I was wondering if you could do multiple section views and put them all on one section view. Say for example. I have a circle, and I put a section view down the center. It will show me that section, but what if I want to add in two more separate section views within that view. Is such a thing possible when drafting. Here's a picture for an example.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Section Views
- Thread starter Geno678
- Start date
- Thread starter
- #2
Sort of.
When you draw your cutting plane, instead of a straight line crank it through the points of interest.
When you draw your cutting plane, instead of a straight line crank it through the points of interest.
Posting guidelines faq731-376 (probably not aimed specifically at you)
What is Engineering anyway: faq1088-1484
What is Engineering anyway: faq1088-1484
- Thread starter
- #4
like this?
Posting guidelines faq731-376 (probably not aimed specifically at you)
What is Engineering anyway: faq1088-1484
What is Engineering anyway: faq1088-1484
- Thread starter
- #6
Not sure about curved cutting planes. Even if SE supports it, it seems ambiguous as to what it would display.
Posting guidelines faq731-376 (probably not aimed specifically at you)
What is Engineering anyway: faq1088-1484
What is Engineering anyway: faq1088-1484
- Thread starter
- #8
- Thread starter
- #9
I figured it out. What I did was, I made a sketch first, I made a few circles and a few lines intersecting my cutting sections, and then I went to cutting plane, and followed those lines exactly the way I put them, and wallah. I was able to get this.
- Status
Similar threads
