sectional view in model

[heavenly]

Hi
how to get sectional view in model,so that i can get clear picture of model for further creation
& also if i take model into drafting mode,views created by
datum planes, how can i remove these planes,witout blanking these planes in model

thanks in before

John

 

[feadude]

the answer to first question coulbe "clipping planes" even though I have only used clipping planes for grips not view model.
For the second part you can move your datum planes to a different layer than model and use "layer visible in view" function in drafting and turn these layers off (invisible).

 

[abeschneider]

heavenly - if you are in NX3, you can produce a sectional view by going: View > Operation > Section This will give you some choices about what type of section view you want. You can use View > Operation > Section Toggle to turn the section On/Off.