Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

seeking source for banana jack

Status
Not open for further replies.

Vanadate

Materials
Jun 20, 2006
5
I am reverse engineering a component and can not find a suitable replacement part. Th part is a 2.5 mm ID/4mm OD tube about 8mm long, bottomed out on one end and flanged on the other. It is used as a banana jack but not sure if that was it's orininal purpose. I have checked pamona, newark, mausser, etc, and no luck. Pomona part 3277 is as close as i have gotten. It is possible the part is a modified version of something stock as it has a spring soldered to bottom. Any help is appreciated. I have attached an image for reference. Thanks
 
Replies continue below

Recommended for you

Blech, DOCX files... one of the many poor decisions MS has made in recent years.

Dan - Owner
Footwell%20Animation%20Tiny.gif
 
I does look a lot like a ferrule, but it is bottomed.

Any idea where I might find one?
 
Hum, Checked out pop rivets but I don't see anything in my part that suggest there was a pull rod attached.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor