Selection of parts within a subassy NX 7.5

[3dr]

Ex:
While "reposistioning"... I used to be able to select a part or sub assy down within another subass'y and it would automatically make that subassy the active work part. Then I could execute.

Now I have to "find" what I want to move in the part navigator first... then go out of my way to make the correct part the work part... then execute my move.

There must be a setting I switch to regain this behavior, yes?

TIA

Dave

 

[jpetach]

Dave,

There is a customer default that should help

(Assemblies_MoveComponentScope)

Assemblies, Positioning, Interface, "Move Component Scope", "Work Part Only"

Regards, Joe