Selection Sets

[gmarken]

Does anyone find that they have a need to use the Inventor selection options such as; component offset, component size, sphere offset or selection by plane? I have been using Inventor now for a couple of years and have never used these commands and do not really see their value. Am I missing something? By my own admission there is alot of functionality that I do not take advantage of and perhaps this is one that I should.

 

[rollupswx]

I understand their use, but haven't needed them. I don't think you are missing anything - especially if you are using logical subassemblies.

 

[mcgyvr]

never used them either... been using INV since R8