We have integrated a REC670 into the MicroSCADA 8.4.4. Monitoring direction works fine and we can read all data from this relay. But we can't match sending commands between relay and MicroSCADA. In MicroSCADA we need for addresses for "open select", "close select", "execute" and "cancel" but there are only 3 addresses in REC670. In REC670, "open select" and "close select" both have one address but different values. Could anyone advise how to solve this mismatch?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Sending Command to REC670 Using LON protocol in MicroSCADA 8.4.4
- Thread starter MuserK
- Start date
Similar threads
- Question
- Question
- Question
- Question