Seperating a body into its own part

[davidinindy]

I have a part with multiple bodies. I want to save the individual bodies as parts, and then "remake" this into an assembly. Bottom line is, I shouldv'e created them as parts, then made an assembly in the first place. Is there a way to do this?

 

[TheTick]

Only the "hard way":

Save copies of your multi-part body and strip out the features that make the unwanted bodies.

"When everyone is thinking alike, no one is thinking very much." --Eckhard Schwarz (1930--2004)

http://www.EsoxRepublic.com

 

[SBaugh]

Use the feature "Split" to save all multi-bodies as separate files.

Regards,

Scott Baugh, CSWP

http://www.3dvisiontech.com

http://www.scottjbaugh.com

If you are in the SW Forum Check out the FAQ section

To make the Best of Eng-Tips Forums FAQ731-376