Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Setting Boots With Laser

Thread starter jafcon1
Start date Apr 10, 2004

Status: Not open for further replies.

Apr 10, 2004

jafcon1

Geotechnical

I need to set boots/hikeups on rough grade lathes prior to undercutting for removal, replacement and compaction of a building pad. Other than setting the lenker rod to the proposed grade I'm confused about how to set the rod for the hikeups. Any suggestions on the best procedure?