Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Setting limit values for nodes rather than integration points in abaqus USDFLD

Thread starter roya22
Start date May 12, 2023

Status: Not open for further replies.

May 12, 2023

roya22

Mechanical

Dear all,

As I know, GETVRM returns values in integration points in usdfld subroutine. I want to set a limit value to fail the elements and as sometimes element nodes reach this value sooner than integration points, I want to set it for nodes rather than integration points.
Does any one know what should I do?

Thank you in advanced