Several type of joints using one WPS

[KevinNZ]

Similar to this tread

https://www.eng-tips.com/viewthread.cfm?qid=446264

I am looking at showing groove a fillet weld preps on the same WPS. Can this done on an ASME WPS or are separate WPSs required?
I have seen this on WPSs, but that does not mean it's the correct thing to do.

Thanks

 

[EdStainless]

Yes, this works fine. Sometimes different welder qualifications are required but not WPS

= = = = = = = = = = = = = = = = = = = =
P.E. Metallurgy, consulting work welcomed

 

[gtaw]

The WPS can become difficult to use if it becomes all too encompassing, but to include both groove and fillets on one WPS shouldn't be too difficult.

Al

Best regards - Al

 

[DekDee]

The most important thing to remember is the main reason for a WPS is to provide guidance to the welder.
As Al stated sometimes too much information is not beneficial - have to find a happy medium.
Hate to think how many times I have seen single WPS's with things like F, V, H, OH - with a range of 80 - 160 amps.
How can that assist anyone ?