Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

SHAFT SLEEVE WEAR

Status
Not open for further replies.
Ronman63

Ronman63

Nuclear
Feb 20, 2008
1
We have Ingersol Rand Vertical pump that has been rebuilt twice in the last 2 years that experiences harden shaft sleeve wear, but yet the cutless bearings experience no wear. It is in a raw water service with lots of sand...Does anyone having any solutions?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Incorporate a fresh water supply to your rubber bearings to help exclude the ingress of sand in the pumped water.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

G
  • Question
Best Choice for Slurry Pump Shaft Replacement
Replies
4
Views
3K
pierreick
pierreick
Wkcoo
  • Locked
  • Question
Can sleeve be polished by oil ring? 1
Replies
8
Views
153
Artisi
A
Rputvin
  • Locked
  • Question
Centrifugal cast iron pump wear rings - switch to brass 2
Replies
8
Views
264
3DDave
3DDave
Daren Samy
  • Locked
  • Question
Float of centrifugal pump shaft
Replies
0
Views
101
Daren Samy
Daren Samy
bmw318be
  • Locked
  • Question
Plunger Triplex Pump- Stiff Shaft cause high current
Replies
8
Views
98
bmw318be
bmw318be

Part and Inventory Search

Sponsor

Back
Top Bottom