Hi, I would like to know what the tolarances is for brace walls that may be a couple (2") inches short per plan. Is there a code reference that would answer this? I am wondering how one will address this if an inspecor were to question the discrepancy withought having to go back to the engineer.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
shear/ brace wall length tollarance
- Thread starter MCORTEZ
- Start date
Similar threads
- Locked
- Question
- Locked
- Question