Sheet Metal - Jog not Flattening

[dedevo]

I have some sheet metal parts that I made by:

Extruding a block
Shelling the block
Split at the corners
Converted to Sheet Metal for each side
Jogged the upper part to create a zero clearance flange

But when I go to "Flatten" that particular piece, the jog remains.

Is there something I am missing? Or is this just the way Jogs behave?

Devon Murray, EIT [Mechanical]
Solidworks 2011 SP 2.0

 

[dedevo]

One of the guys here had seen it before.
Turns out the "Jog" was suppressed under the "Flatten" feature at the bottom of the tree.

Devon Murray, EIT [Mechanical]
Solidworks 2011 SP 2.0