Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Sheet metal template

Thread starter aepeszel
Start date Feb 10, 2005

Status: Not open for further replies.

Feb 10, 2005

aepeszel

Mechanical

I am trying to set up a sheet metal template based on observed results from the shop. The values I have are inside radius and bend deducts per material and thickness.
Is there an easy formula to transfer this into Inventor or would I have to play around to get it? Luckily the bends are typically 90 degrees.