Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

sheetmetal 1

Status
Not open for further replies.
NrM

NrM

Industrial
Oct 24, 2003
8
0
0
CA
I'm a new user of sheetmetal and I'm unable to unbend a oval shape wall with a draft angle. When it's roud with a draft angle it work's,and it also work's when it'a oval without a draft angle. Is their a trick to make it unbend? I'm using wildfire 2.0 . I'm sure a ace of sheetmetal as a trick to unbend that shape.
 
Status
Not open for further replies.

Similar threads

RBobroski
  • Locked
  • Question
Datums stay fixed when unbending or bending sheetmetal revolve
Replies
0
Views
6
RBobroski
RBobroski
TD66
  • Locked
  • Question
Sheetmetal design
Replies
2
Views
3
TD66
TD66
SS65SuperNova
  • Locked
  • Question
Miter cuts in Sheetmetal
Replies
1
Views
10
dbreda
dbreda
Wicsteve
  • Locked
  • Question
Sheetmetal references for Wildfire 4
Replies
0
Views
6
Wicsteve
Wicsteve
Farmboy71
  • Locked
  • Question
Sheetmetal Edge Display 1
Replies
4
Views
5
Farmboy71
Farmboy71
Back
Top