Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

shell manhole neck

Status
Not open for further replies.
pabloespinosa

pabloespinosa

Mechanical
Feb 19, 2003
1
0
0
EC
The neck a 24" diameter manhole was fabricated by rolling and butt welding a steel plate. This was made in shop. Is it necessary to RX the joint to meet the API 650.
If so, where in that code does such requirement appear?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

Kathia Buena
  • Locked
  • Question
5.7.8 Flush-type Shell Connections
Replies
2
Views
24
Kathia Buena
Kathia Buena
Youcef40
  • Locked
  • Question
Using thickened sheet plates to patches shell plates courses. 2
Replies
7
Views
27
Dhurjati Sen
Dhurjati Sen
trolex
  • Locked
  • Question
API 650 - Shell Manhole and Nozzel Inside Projection in a Vessel
Replies
5
Views
13
IFRs
IFRs
Youcef40
  • Locked
  • Question
Can we use the plate A283 Gr C instead of the S 275 Jr in storage tank shell repair? 3
Replies
8
Views
43
Youcef40
Youcef40
Muza33
  • Locked
  • Question
PWHT requirement of shell plate buttweld for API 650 tanks if simulated PWHT required for plates
Replies
6
Views
24
IFRs
IFRs
Back
Top