Mixtli
Structural
- May 21, 2005
- 93
Hi all,
What are your thoughts on a precasting company utilizing engineering drawings as shop drawings?.
What they do is mark up the stamped drawing with their piece mark, attach a bar list, doing a take off from the stamped drawing, i.e. counting the bars on the stamped drawing (dots) and doing the typical N=(concrete width)/spacing+1.
Thanks
M.
What are your thoughts on a precasting company utilizing engineering drawings as shop drawings?.
What they do is mark up the stamped drawing with their piece mark, attach a bar list, doing a take off from the stamped drawing, i.e. counting the bars on the stamped drawing (dots) and doing the typical N=(concrete width)/spacing+1.
Thanks
M.