growlybear
Industrial
I am looking for a source for a shorting bracelet for an old Century Repulsion Start / Induction Run Motor, 1.5 HP, 870 rpm, P10B Frame. Any suggestions?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
SHORTING BRACELETS
- Thread starter growlybear
- Start date
- Status
Bone up on your machining skills!
It's not likely you will find anyone making replacement parts for those old motors. Century has been bought and sold maybe a half dozen times since that motor was made, new owners rarely bother with support for old products.
"If I had eight hours to chop down a tree, I'd spend six sharpening my axe." -- Abraham Lincoln
For the best use of Eng-Tips, please click here -> faq731-376
It's not likely you will find anyone making replacement parts for those old motors. Century has been bought and sold maybe a half dozen times since that motor was made, new owners rarely bother with support for old products.
"If I had eight hours to chop down a tree, I'd spend six sharpening my axe." -- Abraham Lincoln
For the best use of Eng-Tips, please click here -> faq731-376
I was able to find a piece of wire suitable for restringing the "jewelry" years ago. The last time I saw a Repulsion/induction motor was almost 40 years ago and it was old then. (Very old)
Good luck.
Bill
--------------------
"Why not the best?"
Jimmy Carter
Good luck.
Bill
--------------------
"Why not the best?"
Jimmy Carter
- Status
Similar threads
- Locked
- Question