shot peening process using ANSYS

[riodinhoraj]

i'm an doing a research on shot peening using ANSYS.. I have never previously used ANSYS, so i was wandering how to do this process using ANSYS. I'm very new to ANSYS so step by step instructions will be best..please help..thank you

 

[fuzzdoug]

start with tutorials and validation in the ansys help on transient structural.
consider the explicit dynamics solver.
look at the documentation and consider your specific needs/requirements as you build knowledge of the software.

read, read, read, experiment, google, etc.

 

[riodinhoraj]

so to perform shot peening in ANSYS 13.0, i have to use the trasient structural tab in it..cause in the workbench they have a lot of toolbox i.e ( vibration,thermal and so on)..