SIEMENS ET200S AND ET200M

[saradikole]

HELLO
WHICH SOFTWARE IS USED TO PROGRAM SIEMENS ET200S AND ET200M ?
thank you

 

[controlsdude]

These modules are a distributed network that is either profibus, profinet, ASi, or IO-Link(not sure what this network is?). So your plc programming software can be anything that interfaces to these networks.

https://www.automation.siemens.com/salesmaterial-as/brochure/en/brochure_simatic-et200_en.pdf

So the plc can be any manufacturer that offers network interfaces to these networks.
AB, ABB, Siemens, AutoDirect, etc....

Get the big picture?

 

[djs]

The ET200S can also use a Siemens processor instead of a Profibus interface. In that case the Siemens TIA portal software would be used.

 

[123MB]

Hi Saradikole

ET200M and ET200S are Siemens brand remote I/O products which are mostly applied with S7 plcs.

Hence the software you need is STEP 7/TIA Portal