Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

SIEMENS ET200S AND ET200M

Status
Not open for further replies.

saradikole

Electrical
Feb 18, 2018
1
HELLO
WHICH SOFTWARE IS USED TO PROGRAM SIEMENS ET200S AND ET200M ?
thank you
 
Replies continue below

Recommended for you

These modules are a distributed network that is either profibus, profinet, ASi, or IO-Link(not sure what this network is?). So your plc programming software can be anything that interfaces to these networks.


So the plc can be any manufacturer that offers network interfaces to these networks.
AB, ABB, Siemens, AutoDirect, etc....

Get the big picture?
 
The ET200S can also use a Siemens processor instead of a Profibus interface. In that case the Siemens TIA portal software would be used.
 
Hi Saradikole

ET200M and ET200S are Siemens brand remote I/O products which are mostly applied with S7 plcs.

Hence the software you need is STEP 7/TIA Portal
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor