hoolito
Industrial
- Oct 10, 2012
- 30
Hi there,
I am running a rMBP 15" with 2.66Ghz processor en 16Gb Ram. This is non Siemens-certified hardware but I took my chances some years ago with a MBP 17" 2009 and I am really VERY satisfied with it.
This new configuration really flies*
But I am having a problem with.... translators. IGES and STEP translators work fine when exporting/importing to a new part but not when the destination is the work part. GTAC says they can't reproduce the problem with the parts I sent and that the only difference they see between their system and mine is the graphics card I am using (The assumption being that the process terminates because the driver can't draw the imported geometry) ...
How big is the community out there with a similar setup? Is anybody experiencing something similar?
And a Merry Christmas in advance to all!!
Julian
*(disclaimer: with two-sided illumination unchecked)
I am running a rMBP 15" with 2.66Ghz processor en 16Gb Ram. This is non Siemens-certified hardware but I took my chances some years ago with a MBP 17" 2009 and I am really VERY satisfied with it.
This new configuration really flies*
But I am having a problem with.... translators. IGES and STEP translators work fine when exporting/importing to a new part but not when the destination is the work part. GTAC says they can't reproduce the problem with the parts I sent and that the only difference they see between their system and mine is the graphics card I am using (The assumption being that the process terminates because the driver can't draw the imported geometry) ...
How big is the community out there with a similar setup? Is anybody experiencing something similar?
And a Merry Christmas in advance to all!!
Julian
*(disclaimer: with two-sided illumination unchecked)