Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Simple question on deleting components

Status
Not open for further replies.
protrader

protrader

Mechanical
May 26, 2008
24
0
0
CA
Hello,
I need to delete a lot of components and keep some of them. Is there any way to do this not one by one? like any way to delete only the selected components?
TIA
PS: I am using ANSYS 12.0
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Try this using the "Component Manager" dialog box.


------------
See faq569-1083 for details on how to make best use of Eng-Tips.com
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

TeoAlfa
  • Question
ANSYS Mechanical - Concrete embedded steel components
Replies
0
Views
28
TeoAlfa
TeoAlfa
IJR
  • Question
On how and where to insert command snippets inside Workbench mechanical
Replies
2
Views
26
IJR
IJR
HarryBaals
  • Locked
  • Question
Simple Fix for an experienced Ansys Static Structural user
Replies
3
Views
10
SPDL310
SPDL310
bkal
  • Locked
  • Question
Mode Selection Based on the Mode Coefficients
Replies
0
Views
11
bkal
bkal
shiraz883
  • Locked
  • Question
Stresses increase on adding thermal boundary conditions/ thermal load
Replies
1
Views
11
SWComposites
SWComposites
Back
Top