Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Simulation and laws

Thread starter RogerJames
Start date Aug 17, 2006

Status: Not open for further replies.

Aug 17, 2006

RogerJames

Automotive

I'm looking for a way to control a mechanisim in DMU thru a spread sheet. I could also settle for a way of defining a law using a curve. I know you can make a curve in GSD but I can't find a way of pasting it into DMU.

Eventually, I would like to control three or more motions thru this method.

Any and all ideas are welcome and appreciated. Thanks!

Roger James
Erie Engineering
Stamping Dies and Automation