I have file with a lot of data, for example here is a file with this data -> time: 1 2 3 4 5 6 7 8 9 10 data: 1 0 1 1 1 1 1 0 1 0 but in my file i have droped the multiple data going in sequence like this -> time: 1 2 3 8 9 10 data: 1 0 1 0 1 0 (times 4,5,6,7 are skiped) If I run this data the result is this -> My question is how to achieve result like in this picture shown with red arrows. Simplier, how to repeat the value in not defined time steps (4,5,6,7 example above)

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Simulink - From file block - Not defined time steps in .mat file (with examples)

Thread starter Siemonsin
Start date Feb 24, 2014

Status: Not open for further replies.

Feb 24, 2014

Siemonsin

Electrical

I have file with a lot of data, for example here is a file with this data ->

[ignore]time: 1 2 3 4 5 6 7 8 9 10
data: 1 0 1 1 1 1 1 0 1 0[/ignore]

but in my file i have droped the multiple data going in sequence like this ->

[ignore]time: 1 2 3 8 9 10
data: 1 0 1 0 1 0[/ignore]

(times 4,5,6,7 are skiped)

If I run this data the result is this ->

My question is how to achieve result like in this picture shown with red arrows. Simplier, how to repeat the value in not defined time steps (4,5,6,7 example above)