Sketch constraint

[CADone]

Just by looking at a sketch is it possible to tell if a sketch is fully constraint. Any color codes?

 

[btrueblood]

On my installation of Inv 2009 (and was this way for all prior versions back to R10, default color settings) the sketch lines change from green (unconstrained) to black (fully constrained).

 

[mcgyvr]

In 2009
#1 line colors change as stated above.
#2 in the bottom right hand corner (around the memory meter area) it will also tell you how many dimensions you need as well as saying when its fully constrained.

 

[rollupswx]

In addition to the color change for fully constrained sketch and the prompt in lower right corner of screen

- you can also turn on visibility of Degrees of Freedom for sketch entities or use Autodimension to add constraints and/or dimensions.