Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Sketch Tab and Axis

Status
Not open for further replies.

Md. Enamul Islam Meraj

Geotechnical
Feb 29, 2024
2
In Abaqus software, while i try to sketch, It's always in z axis on which i have to draw the part. Can i change the axis?


My problem is that, I have to create a sloping soil surface and then insert a pile in the sloping face. But the cut in the slope face for pile is always perpendicular to the pile part in assembly option. So if i could change the axis of sketch, it would be nice.


I am completely new to this software and this forum also. So i really don't know much. Thank you in advance.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor