krustykrabs
Automotive
Has anyone tried creating a sketch in an assembly, and then tried to iges out the assembly? Did the sketches disappear?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Sketching in assembly mode
- Thread starter krustykrabs
- Start date
- Status
Interesting. I just tried to do this in SW2003, and I can't I have the options to export sketches to IGES selected. Only part sketches get exported. Assembly level sketches are left behind.
Perhaps you can make a temporary part and copy the sketch entities (via "Convert Entities") to that part.
![[bat]](/data/assets/smilies/bat.gif "[bat] [bat]")
Due to illness, the part of The Tick will be played by... The Tick.
Perhaps you can make a temporary part and copy the sketch entities (via "Convert Entities") to that part.
Due to illness, the part of The Tick will be played by... The Tick.- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question