Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Skewed Nozzle Centered on a Flat Head

Status
Not open for further replies.
gmp2012

gmp2012

Nuclear
Sep 18, 2012
2
Hello,

Could anyone advise how to model a skewed nozzle right in the center of a flat head using NozzlePro 8.5(FE/PIPE 6.5)?

Thank you,
GP
 
Status
Not open for further replies.

Similar threads

SmallInfo
  • Locked
  • Question
How to Control Nozzle Loads?
Replies
1
Views
355
LittleInch
LittleInch
Babak3
  • Locked
  • Question
Using stiffeness in the nozzle of the vessel
Replies
2
Views
519
StressGuy
StressGuy
az5333
  • Locked
  • Question
ANSI Pump Allowable Nozzle Loads Vs Actual Loads
Replies
1
Views
160
Nicolas B
Nicolas B
YadavAS
  • Locked
  • Question
Nozzle Load Issue
Replies
1
Views
95
richay
richay
TomoB
  • Question
Modeling fittings acc. to ASME B16.11
Replies
2
Views
2K
TomoB
TomoB

Part and Inventory Search

Sponsor

Back
Top Bottom