Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

slab release in SAP

Thread starter lbengineer1
Start date Dec 30, 2014

Status: Not open for further replies.

Dec 30, 2014

lbengineer1

Civil/Environmental

i have to model a slab supported on its edge on walls.
the model is made on SAP and of course a negative moment is created in slab at support .
i would like to make the connection between the slab and the wall released for bending so that no moment transmission happens and the slab act simply supported.
can i have an advice on how to do that in SAP?