MFDO
Mechanical
- Aug 10, 2005
- 217
Attached is a Parametric designing process I adopted in NX, using my past experience. You may notice that the modifying/adding/deleting components and their respective Pocketing (with basic commands) happening parametrically.
Initially I posted this short clip in NX Forum to show my working processes since one NX “Expert” mentioned that it needs be more than a rookie (Design process) to get the most out of NX.
It would be interesting to see your concepts of better or smarter ways of working with NX.
Michael Fernando (CSWE)
Tool and Die Designer
Siemens NX V9.0 + PDW
SWX 2013 SP3.0 X64
PDMWorks 2013
Logopress3
FastForm Advance
FormatWorks
Initially I posted this short clip in NX Forum to show my working processes since one NX “Expert” mentioned that it needs be more than a rookie (Design process) to get the most out of NX.
It would be interesting to see your concepts of better or smarter ways of working with NX.
Michael Fernando (CSWE)
Tool and Die Designer
Siemens NX V9.0 + PDW
SWX 2013 SP3.0 X64
PDMWorks 2013
Logopress3
FastForm Advance
FormatWorks