Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

smoothing blends in NX

Status
Not open for further replies.

Helmi Bouali

Mechanical
Aug 18, 2022
1
I was told that a feature that does just this exists in Catia (i can't remember as i haven't used Catia in a long time) but i'll post pictures below to show what kind of result i want (obviously i used trim surface, fill surface and sew again to get this)

before_or4aj5.png

after_piwog9.png


is there any such command or a custom configuration in the classic edge blend command that gives similar results?

Thanks in advance!
Helmi Bouali
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor